Digi-star RF DataLink Operators Manual User Manual download pdf (Page 10)

RF DataLink

Extended Range Setup

If you are using the extended range radio kit (RS-422) you must

go to System, then Defaults, and select [Radio Settings]. Under

Base Radio Type, select [Extended Range Base Radio (RS-422).

RF Datalink will then pause while looking at the radio for the new

settings.

Next open the housing of the base radio. There is a bank of dip

switches on the right side,

Set switches as the picture on the right:

Install the AC/DC power transformer into the base radio box and run AC power into the unit

as shown. When attaching the female plug to the power cord, remove green ground wire

and attach either of the remaining two wires to either terminal. AC/DC adaptor is not

polarized.

Antenna Assembly

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

No comments

Digi-star RF DataLink Operators Manual User Manual Page 10